Ketika Tails mulai, perangkat Wi-Fi, WWAN, dan WiMAX diaktifkan.

Tetapi semua perangkat nirkable lainnya seperti Bluetooth, GPS, dan alat-alat FM dinonaktifkan secara default. Jika Anda ingin menggunakan perangkat tersebut, Anda harus mengaktifkannya dulu.

Enable a wireless device

Teknik ini memerlukan command line.

  1. When starting Tails, set up an administration password.

  2. To find out the index of the wireless device that you want to enable, open a root terminal, and execute the following command:

    rfkill list
    

    Sebagai contoh, perintah tersebut dapat mengembalikan hasil seperti berikut:

    0: phy0: Wireless LAN
            Soft blocked: no
            Hard blocked: no
    1: hci0: Bluetooth
            Soft blocked: yes
            Hard blocked: no
    2: gps0: GPS
            Soft blocked: yes
            Hard blocked: no
    

    The device index is the number that appears at the beginning of the three lines describing each device. In this example, the index of the Bluetooth device is 1, while the index of the GPS device is 2. Yours are probably different.

  3. To enable the wireless device, execute the following command in the root terminal, replacing [index] with the index found at step 2:

    rfkill unblock [index]
    

    Here is an example of the command to execute. Yours is probably different:

    rfkill unblock 2
    
  4. To verify that the wireless device is enabled, execute the following command in the root terminal again:

    rfkill list
    

    This output should be very similar to the one of step 2, but the device enabled at step 3 should not be soft blocked anymore.

    Sebagai contoh, perintah tersebut dapat mengembalikan hasil seperti berikut:

    0: phy0: Wireless LAN
            Soft blocked: no
            Hard blocked: no
    1: hci0: Bluetooth
            Soft blocked: yes
            Hard blocked: no
    2: gps0: GPS
            Soft blocked: no
            Hard blocked: no